Foil Forum

Great - will look forward to hear how they go. I hope they go well because they look great to me, Love to know Sequres reasoning behind their comment.

ecpow: battery setup is 12s10p For that you definitely chose the wrong curve!! The current you choose is what you estimatedly consume when foiling, per cell! So with 10A curve and 10p that equals 100A battery current. At 12S, thats 4kW, I assume you don’t use that much? For a more realistic 1kW foiling power you need a curve for 2.5A/cell… DxMxK: try and recreate it and get a video this weekend. That would be helpful, as in your case I don’t really see any obvious error in the configuration…

Yes, two in fact.

Thanks for the advice—it was basically a waste of money; I only used it twice. I thought it was just a minor leak. FlipSky refuses to honor the warranty. I’m really frustrated. Terrible remote control.

Great, could you tell me where I can buy the Maytech and whether it supports UART/VESC telemetry with the FlipSky 65220?

Price reduced to 850Eur + shipping.

This is almost all. A Bremote Nano RX with GPS sitting between the batteries. In this case my 12S4P 21700 20Ah. In the back is a flipsky 6,7Pro. Thats it. For cooling i soldered a piece of Cooper and two brasspipes together and glued it on the FETs. The Website has no english version yet. So all you got is the chrome translate version.

My issue is similar to ecpow in that it has read the correct battery percentage for a short amount of time (10-30s) before displaying 99. Mine does not decrease during a riding session, stays at 99 the whole time. The times I have gotten it to display the correct battery percentage have been after I updated the configuration or SW version. I don’t recall if I had pulled the throttle and the displayed changed, I don’t think so, it has always been on dry land when setting up and testing. I can try and recreate it and get a video this weekend. Info for my battery: 12s14P - Samsung INR 18650-30Q 3000mAh I used 2A - current per cell and 0 offset for battery voltage, as it matched the measured voltage. Encoded Data Read: KtzRzs3My8rJycjIyMfHxsbFxcXEw8PCwcC/vry7urm4uLe2tbS0s7KysbCwr66trKyrqqmop6alpKOioaCfnp2cm5qZmJeWlZSTkpGQj46NjIqIh4WDgH58eXd0cm9tamZjXllS batcal: noload_offset: 0.08V, 100% rem. @ 4.20V, 0% rem. @ 2.82V.

ok so a couple of items: Your site is great, but some pages don’t flip language. I’m not sure if you set that up or if that’s just chrome being chrome. (in particular the propellers page) Also it would be great if you had notes about the propeller performance. Second I was looking for info on your heatsink/water cooling setup. Didn’t find it. Also I didn’t see any compartment layout (batteries, controller, etc) I did see batteries but now how you fit all that stuff into that thin board! Please share! Again, fantastic, keep it up Keep it up, this is great work!

My brother in nerd. Fantastic.

See this vid around 2 minute mark - YouTube

I finally got my setup working and in the water yesterday and it had looked like my battery had died very quickly. After charging and plugging everything back in the remote won’t pair. It turns on and the esc beeps when pigged in. I have no lights on the remotes receiver so I’m thinking maybe that is the issue? Can someone please confirm if the receiver should have a light on? The remote and esc are second hand.