LightBurn Software Forum Forum

Hello everyone, I need some help troubleshooting a connection problem between my laser engraver and LightBurn. My machine has: Controller: MKS DLC32 Firmware: GRBL 1.1h Laser: 5.5W diode laser Work area: X …

Not sure what is going on. I noticed my lightburn did some changes now with power set on 2% it is showing about 16ma on the gauge. Normally it should be at about 7ma. it has been quite awhile since I had any problems o…

I’m 82 years old and don’t have time to figure out what’s wrong with 2.1.04. PLEASE help me get back to an older version,please!

I am cutting photo stands and the laser is making 2 passes but LB is only set to 1 pass, I have a ran the “find duplicate” but it said none found.

I bought a generic Chinese 3018 CNC machne a while back and tried to use Millmage and gave up. When the new version 0.9 came out I thought I’d try it again, but still no luck. I make a simple text layer, convert it to a …

I just got an XTool S1 (10W, maybe the last one :grinning_face: ) I was able to connect and burn something with the XTool Studio. Now I’m trying to get it to work with the latest LightBurn (2.1.04) (I’m new to both S1…

Just started today, been running the same settings for 1.5 yrs & then out of the blue…Im unable to frame with the laser head moving just a few mm.I have deleted all the files from the controller. I also have tried framin…

DO NOT post your License Key If your issue requires LightBurn staff attention, please email us at support@LightBurnSoftware.com - this is a public forum p300-Mat-2.lbrn2 (68.5 KB)

Hi, I was hoping someone might be able to point me in the right direction with regards to an issue I’m having where my laser tube has stopped firing. It’s a 60w tube with a new power supply on a Chinese machine. When I p…

Bonjour, oui j’ai bien une licence Core à jour et je voudrais faire l’essai de la version pro avant de l’acheter car les nouvelles fonctions m’intéressent. Comme il m’a été répondu dans mon précédant message, quand je va…

I downloaded and paid for Millmage Pro this morning but my screen still shows it as Pro 9.00 RC 7 is this correct?

Tip: Quick pre-check for broken DXFs that cause “open shapes” warnings*** If you’re getting open shapes / duplicate lines warnings on client DXFs (especially from Illustrator), I’ve been using a free browser tool I bui…