Redpowermagazine Forum

Auction coming up couple miles from me with a IHC T-9 with factory rubber tracks. Probably stuck, burns too much gas, but maybe go cheaper than the guy quoted me a couple years ago. I want it, but I don't want it, know what I mean?

Cleaned it up some on the 730 I haven’t done the 650 yet

Those things are loud. I spent two weeks making cove with the exact set in a radial.

Wish I could post a pic! 🤷🏻‍♂️

Sounds like a nice haul.

There is a McCormick 100 manure spreader on an auction this Saturday about 3 miles from me. It’s on Equipment Facts already at $466. Don’t know if I’ll get that bought. It’s had very little use and has new tires. I was hoping to get it for $400-500 but if it goes for less than $1000 I’ll be surprised at this point. I got into the BN I just purchased. Didn’t take too much to get it running, battery and clean out the fuel system. I have the parts for a buddy seat, got the floor pan cut and mounted today. Hope to have it painted in a couple weeks with a #16 mower on it. The guy I bought the BN from is cleaning up a property that he’s selling in Missoula. He used to run the New Holland dealership in Missoula. I filled the truck today digging through parts boxes and stripping a couple tractors. Two sets of rear weights, a set of splits, set of Cub front weights, two sets of Letter front weights, M draw bar, seat and suspension from 1066 hydro, muffler from that and hydro lines from its loader. Bunch of odds and ends too. If I think I might use it, threw it in. I’ll go back again to get the pto unit from the 1066 and hydro blocks from under the seat. All that should fit my 806 if I need them. That tractor has a ventilated block and is going to scrap.

‘Back in the day’ as a hired hand, the farm operator was fortunate to have a herd of beef cows, 3rd cut generally went into silos for the beefers, dry cows, and heifers. Although I do remember once or twice over those years baling hay(small squares) in October and November.

IF we had pics working, the manual I posted in this thread would be helpful. It goes through all of this. You can see the images if you Google redpowermagazine.com acem electrical manual.

Just pay the house off sooner!

I'm thinking ambac and a locating pin that had a spot of epoxy to hold it in. Can't remember anymore right now.

He wouldn’t like a 3 tooth molding head then would he? https://www.ebay.com/itm/327335250223?chn=ps&norover=1&mkevt=1&mkrid=711-117182-37290-0&mkcid=2&mkscid=101&itemid=327335250223&targetid=2295557531950&device=m&mktype=pla&googleloc=1027378&poi=&campaignid=21404249913&mkgroupid=173029508828&rlsatarget=aud-1412318123216:pla-2295557531950&abcId=9450098&merchantid=427105305&gad_source=1&gad_campaignid=21404249913&gbraid=0AAAAAD_QDh__NCJEsGrSzppnuvkg9UIfc&gclid=Cj0KCQjwh4TVBhCWARIsAG0czmpkb4Osjtt4kX9BsUgu10KUBlvH1Eo09I1glky9YXFW6nnI9Tks2x4aAigCEALw_wcB