I LOVE Android Auto and the Nav. I want to get a cell phone holder for my 2010 R1 and Galaxy S26 Ultra. What do ya recommend?? I was thinking about RAM. But a couple people said the quality went down hill
Yamaha R1 Forum: YZF-R1 Forums
www.r1-forum.com ↗XenForo forum in English. 4 sections tracked: Appearance & Mods, Bike Parts Classifieds, General Motorcycle Discussions and Mechanical / Help.
- Discussions per day
- 7
- Discussions collected
- 135
- Messages per day
- 23
- Sections
- 4
- Sources tracked
- 5
- Engine
- XenForo
Latest discussions
Collected every 4 hours from the forum's public feed. Only the title, the link and the beginning of the message are reproduced; every link points back to the source.
I just picked up my fourth one. 🙃 My first one that isn't blue... I won't make the same mistake and sell it this time. 2003 Raven/with red flames.
I just picked up my fourth one. 🙃 My first one that isn't blue... I won't make the same mistake and sell it this time. 2003 Raven/with red flames.
QLD'er -i just rescued this from down in Victoria headed for parting out -rescued now... It's rear is stretched and has 'los vegas.com bikes' on the swing-arm. If anyone recognises it i'd love to know it's past👍
so I got a r1 that was flashed already now I remember getting my old 2017 flashed and they recommended me to keep it in power mode 3. do to the flash on that map... really not sure if it matters what power mode I ride on this 2020 not sure if it will effect how it runs it has a mid pipe y . do you guys think it should be ok to ride it in any power mode or should I try and track down who did the flash ? I'm new to the techy bikes lol
Hi . My 99 r1 has no spark i believe after loads of testing ect . Its an no earth in the saftey cut out side. Its cranks but no spark. Pulled the coils tested has 12.4 volts at red and black wires so coils are getting power . Did jump some black wires in cycle lock as thats not fitted to get it to crank . It cranks with stand up or down without the clutch pulled in ?? And have continuity to both switches above .and fuel pump dash ect all work cranks but still no spark witch wire is the... No spark
So I have a 2008 Flatplane R1, and this past weekend I aquired a 2009 Crossplane R1. And well I'm not sure if I like it, I've only had it a couple days and honestly its a different bike completely compaered to my 08. Obviously being completely different was expected, so I don't like the juddering that happens if you take off on low idle first... The R1
Ok, can someone tell me what all the crap attached to the intake is? I know one of them is the map sensor , but what about all the others and what they do. If I tuned the flapper out is any of this needed besides the MAS sensor
Does anyone have a wiring diagram with color codes of the wires listed for the 2015 R1? I am trying to find the switched ignition wire that comes off the ignition switch. Basically a switched wire source. I tried the brake light wire and that somehow didnt work out for me. As the voltage threshold dropped to 8 volts in different scenarios..
Has anyone seen the video of the Robot riding a Yamaha R1M?
I found a 2015 R1 for sale with 35k miles for $8k. What would you be worried failing/causing issues at such a mileage? Does it still have plenty of life left in it or probably not?
Hi I have a customer who has a 98 Yamaha YZF1000R. The exup valve is not working it is throwing a fault up on the dash. So far ive pulled it apart and cleaned all the servo unit, Ive tested the unit by putting power to the + black and yellow and – black and red from a separate battery and it works lovely. The issue is soon as I connect it back on the bike with no cables attached it opens but does not close again is this just a faulty servo motor or is the ICU at fault. Ive also tested the... 98 YZF100R EXUP valve not working?
135 discussions collected since 1 September 2026. Track this forum by keyword →