Foro S10forum

my '96 Blazer sometimes makes a crack or pop noise when backing up and turning. Normally I'd say something lose or worn in the front end but Ive checked everything and found nothing. Its only occasional, so I'm not worried about it. BUT,,,, a customer brought her newly purchased '99 Blazer into the shop last week complaining of the same thing. Again, I checked the front end, all good (it only has 65K miles, very clean and well cared for), rear bushings/shocks, fine, mounts fine. I could not... "crack" noise on turns in reverse?

my '96 Blazer sometimes makes a crack or pop noise when backing up and turning. Normally I'd say something lose or worn in the front end but Ive checked everything and found nothing. Its only occasional, so I'm not worried about it. BUT,,,, a customer brought her newly purchased '99 Blazer into the shop last week complaining of the same thing. Again, I checked the front end, all good (it only has 65K miles, very clean and well cared for), rear bushings/shocks, fine, mounts fine. I could not... "crack" noise on turns in reverse?

Hello all, I am lowered 3" on maxspeedingrods blocks right now and am moving to 3" lowering leafs, with the blocks I currently have shakes around 40 mph and 60 mph and have a custom one piece driveshaft and an extended cab. I am wondering if this is most likely a driveshaft issue or a pinion angle issue. if anyone has any info that would be greatly appreciated, thanks!

Hello all, I am lowered 3" on maxspeedingrods blocks right now and am moving to 3" lowering leafs, with the blocks I currently have shakes around 40 mph and 60 mph and have a custom one piece driveshaft and an extended cab. I am wondering if this is most likely a driveshaft issue or a pinion angle issue. if anyone has any info that would be greatly appreciated, thanks!

So I have this 49 Hudson powered by a 90’s S10 4.3 TBI with a 700R4. Got it in July and been slowly improving it but still a ways to go. It had a huge problem with the coolant temperature sensor. Replaced it, ran fine for 300 miles. Seemed to go bad, replaced it again. Ran about 6 miles, ran bad again. Replaced the CTS pigtail this morning and runs much better. The issue I’m having is it will start and run fine but stumbles/bogs on hard acceleration. Fuel... 90’s S10 Powered 49 Hudson

Truck ran fine yesterday, no problems at all. Today I took it out and the speedometer didn't work, and the emergency brake dummy light was on. After 5 minutes of driving the "service engine soon" light came on. The upshift light never comes on either. Is it normal for the e-brake light to come on when there is a speedo/odo failure like this? This is a 95, which has the ODB1.5 system that nobody has a reader for, so I'm hoping ya'll can help me troubleshoot it. Charlie.

Truck ran fine yesterday, no problems at all. Today I took it out and the speedometer didn't work, and the emergency brake dummy light was on. After 5 minutes of driving the "service engine soon" light came on. The upshift light never comes on either. Is it normal for the e-brake light to come on when there is a speedo/odo failure like this? This is a 95, which has the ODB1.5 system that nobody has a reader for, so I'm hoping ya'll can help me troubleshoot it. Charlie.

So I replaced my fuel pump and how I replaced it, I took the bed off the truck and meanwhile removing the bed I removed a wire with it as well not knowing it was there so after I fixed the fuel pump and replaced it with a new one. My passenger side tail light doesn’t function whenever I turn on the headlights, then I put the blinker and it doesn’t flash whenever I press the brake the tail light turns off whenever I go in reverse the bulb doesn’t turn on.

NEW THREAD FOR THE NEW TRUCK! So, after my First LS-S10 was stolen and wrecked on july 17th, I found a 1992 Sonoma GT in frost white/Argent Grey for sale down the street from my house... I managed to get a loan and buy her on July 26th. After I gave her a good scrubbing. ... Project Betty White; The nitemare reborn

NEW THREAD FOR THE NEW TRUCK! So, after my First LS-S10 was stolen and wrecked on july 17th, I found a 1992 Sonoma GT in frost white/Argent Grey for sale down the street from my house... I managed to get a loan and buy her on July 26th. After I gave her a good scrubbing. ... Project Betty White; The nitemare reborn

So, I ended up in Billings, Montana on another assignment. As usual, I was scanning advertisements and came across this: 1990 Dodge Dakota, 5 speed with A/C! The owner said it had a blown head gasket and was asking $1000. Rust free, and pretty straight, old geezer style cap in the back. The truck spent most of it's life on dirt roads in rural Montana. Just turned 200K miles. It has the 3.9 V6 in it, which is pretty much bullet proof. I figured the head... Look Ma, Another Dakota.

So, I ended up in Billings, Montana on another assignment. As usual, I was scanning advertisements and came across this: 1990 Dodge Dakota, 5 speed with A/C! The owner said it had a blown head gasket and was asking $1000. Rust free, and pretty straight, old geezer style cap in the back. The truck spent most of it's life on dirt roads in rural Montana. Just turned 200K miles. It has the 3.9 V6 in it, which is pretty much bullet proof. I figured the head... Look Ma, Another Dakota.