Forum Line 6

Seeking help. One of my L3ts doesn't power up. Can anybody tell me, where the fuse is located or if there is any at all?

Attached are 2 example presets. Example 1 is the usual way that it's done. Guitar>Helix INPUT Helix SEND 1>5150 INPUT 5150 SEND>Helix RETURN 1 Helix 1/4" LEFT MONO OUT>5150 RETURN Helix XLR LEFT MONO OUT>EVH Hypersonic INPUT If you want to use a Helix amp in addition or in place of the 5150's Preamp you can either place the Helix amp adjacent to the FX Loop with both Bypass assigned to a FS with FX Loop SAVED ON/Helix amp OFF (FS toggles 5150/Helix) as in example 1 or place the Helix amp on the Path 2B Split in front of the Cab as in the second example. There's lots of ways to do this, but in your configuration I think that using 1/4" for your 5150 and XLR for the FRFR would work best. sozorox1.hlx sozorox2.hlx

"I'm-a-wonder'in if the D10 interface when it gets released will do the same job as the interface ... ", NO. D10 designed to function with Stadium series floor effects. It is the interface for Stadium only.

Can't connect Variax to Stadium without the D10. DON'T try to use the Nexus connector as a work around. Check with Customer Support and see they have a estimated release date for the D10.

Hello all, thank you in advance for any help. I have a line 6 Helix LT. I would like to run the left output to my 5150iii combo, and the right output to a evh hypersonic FRFR cabinet, using an amp and cab Sim. I've tried following some YouTube videos, but when it comes to panning my signal, something isn't working right. I know it can't be that difficult. Thanks in advance.

Has anything changed in your local wifi setup? Perhaps an automatic update to your router or PC software? https://kb.line6.com/helix-stadium-software-wifi-drop-outs-intermittent-connection

Have not had any issues with the wifi since initial set up. Running Windows 11 and it started not connecting (I use the static IP). Then, I get it to connect and it drops out after a minute. Then I get it to connect and it freezes. No settings have been changed, so wtf?

I did a factory reset and the rotary effects appeared on some of the factory presets. The Eric + Jimi had three of them available. Then when I reloaded my backed-up presets they disappeared on the Eric + Jimi choices. rd2rk; not sure how to access legacy and stereo categories. Thanks, sh Thanks SaschaFranck, sh

From that pulldown:

Thank you silverhead, Dark-Star (used to be psarkissian@line6).

Cotton swab, alcohol, drip it onto the piezo/saddle, let it work its way in, then blow out with canned air. Repeat if needed. If it still persists, take it your nearest authorized service center and have them check further and deeper.

Comparing to my 700 Electric Rev-A,... the one in the photo is a 700 Electric, Rev-B,... 96% certain when comparing to the photo. If it were an acoustic in a electric, you'd be getting weird sounding acoustic patches with all kinds of frequency artifacts.