I already have a Unaka roof rack on, but after reading about leaks, I'm inclined to be proactive with some sealants. I don't want to take off the rack, and it was difficult to get some of the mounting brackets onto the tabs, so building things up underneath them doesn't seem like a great idea. My plan is to use Sikaflex 221 on the seams that run most of the length, and then use Dicor self-leveling sealant around the tabs and roof rack attachment points. Is there a better way to do this?
Forum Ram Promaster Forum
www.promasterforum.com ↗Forum XenForo en anglais. 5 rubriques suivies : Electronics, Engine and Technical Discussion, New Member Introductions, Promaster Builds and Conversions et Promaster General Discussion Forum.
- Discussions par jour
- 11
- Discussions collectées
- 189
- Messages par jour
- 17
- Rubriques
- 5
- Sources suivies
- 6
- Moteur
- XenForo
Dernières discussions
Relevé toutes les 4 heures depuis le flux public du forum. Seuls le titre, le lien et le début du message sont repris ; chaque lien renvoie à la source.
I already have a Unaka roof rack on, but after reading about leaks, I'm inclined to be proactive with some sealants. I don't want to take off the rack, and it was difficult to get some of the mounting brackets onto the tabs, so building things up underneath them doesn't seem like a great idea. My plan is to use Sikaflex 221 on the seams that run most of the length, and then use Dicor self-leveling sealant around the tabs and roof rack attachment points. Is there a better way to do this?
So we were driving down yet another horrible rutted forest road and suddenly the right front brake started squealing like crazy. This has happened before, and usually just backing up a few feet dislodges whatever's going on and we're on our merry way. But today it would not stop squeaking. Finally pulled into the campground, got the jack out so I could see what's going on: Here is the culprit : A closer look... Shrieks of terror: rock stuck under brake shield
Hi, This is a video from a couple that had a fire in their LiFePo4 batteries. Quite a bit of detail on the fire department response and precautions they had taken and additional precautions they plan to take. Li Battery Fire Video... Its not clear to me (or them) what caused the fire. They think it might have been the BMS. But, I suppose it could have been a cell failure, bad connection, overload, ... Or?? An interesting thing... LiFePo4 battery fire in RV
I am camping for 14 days at the Fair, 100% self contained. Two biggest users are ecoflow wave 2 heat pump (used for about four hours each night on eco mode) and a 1.5 gallon water heater (one load of hot water each day). I have a max air fan i leave on low during the day. I charge my cell phone nightly and use to small fans, water supply pump, and lighting. I have my efficient compressor fridge running per its internal thermostat. I make rare use of microwave. Days are mostly sunny. I... 400w solar barely enough
I am camping for 14 days at the Fair, 100% self contained. Two biggest users are ecoflow wave 2 heat pump (used for about four hours each night on eco mode) and a 1.5 gallon water heater (one load of hot water each day). I have a max air fan i leave on low during the day. I charge my cell phone nightly and use to small fans, water supply pump, and lighting. I have my efficient compressor fridge running per its internal thermostat. I make rare use of microwave. Days are mostly sunny. I... 400w solar barely enough
Is there any way to prevent the cargo lights from timing themselves to shut off when in the manual "on" position? Mine will shut off after about 15 min regardless of anything else, which is super annoying. They will not relight unless all the doors are first closed. Last night I was unloading a milling machine down ramp and the bloody things shut off, leaving me balancing an 800 pound lump halfway down a ramp in the dark. Since there was a ramp up to the back of the van I couldn't close... Cargo light timing
Is there any way to prevent the cargo lights from timing themselves to shut off when in the manual "on" position? Mine will shut off after about 15 min regardless of anything else, which is super annoying. They will not relight unless all the doors are first closed. Last night I was unloading a milling machine down ramp and the bloody things shut off, leaving me balancing an 800 pound lump halfway down a ramp in the dark. Since there was a ramp up to the back of the van I couldn't close... Cargo light timing
I'm in the process of a simple conversion of a 2020 136 HR. It comes with a single cargo light that looks like this: The stock cargo light has a 3 position switch, so I thought these couple of threads might be helpful: My new cargo area LED lights Today I installed some LED light strips in the cargo area of my 2017 2500, wired to the dome light near the side door so they come on and turn off with the dome lights. I saw a video that briefly indicated that, after the lights timeout, you can press the side door closure switch to simulate... www.promasterforum.com Cargo area lights When putting my ceiling in I had to remove the factory dome lights in the cargo area. Have any of you hooked those circuits up to new lights mounted somewhere so that you have lights when the doors open? Josh Sent from my SM-P900 using Tapatalk www.promasterforum.com Upon removing the light... 2020 Cargo light wiring
I'm in the process of a simple conversion of a 2020 136 HR. It comes with a single cargo light that looks like this: The stock cargo light has a 3 position switch, so I thought these couple of threads might be helpful: My new cargo area LED lights Today I installed some LED light strips in the cargo area of my 2017 2500, wired to the dome light near the side door so they come on and turn off with the dome lights. I saw a video that briefly indicated that, after the lights timeout, you can press the side door closure switch to simulate... www.promasterforum.com Cargo area lights When putting my ceiling in I had to remove the factory dome lights in the cargo area. Have any of you hooked those circuits up to new lights mounted somewhere so that you have lights when the doors open? Josh Sent from my SM-P900 using Tapatalk www.promasterforum.com Upon removing the light... 2020 Cargo light wiring
Join Us At TACONIC STATE PARK (COPAKE FALLS), NY First Weekend In October 2nd and 3rd Fall Camping in the Empire State, Fall Colors, Chill in the Air, Bit of History, Beautiful Vans Taconic State Park is located along 16 miles of the Taconic Mountain Range, sharing a border with Massachusetts and Connecticut. With Two areas to explore, Copake Falls and Rudd Pond, it offers an extensive trail system, offering spectacular views. The Campground has centrally located restrooms and shower... Fall Van Meet-up in the Empire State Oct, 2-3 2026
Join Us At TACONIC STATE PARK (COPAKE FALLS), NY First Weekend In October 2nd and 3rd Fall Camping in the Empire State, Fall Colors, Chill in the Air, Bit of History, Beautiful Vans Taconic State Park is located along 16 miles of the Taconic Mountain Range, sharing a border with Massachusetts and Connecticut. With Two areas to explore, Copake Falls and Rudd Pond, it offers an extensive trail system, offering spectacular views. The Campground has centrally located restrooms and shower... Fall Van Meet-up in the Empire State Oct, 2-3 2026
189 discussions collectées depuis le 2 septembre 2026. Suivre ce forum par mot-clé →