Forum Victron Community

Could you give me a tip on how you'd split up the panels? I'd like to use the Jollywood JW-HD108N-R2 500W modules. I can fit 16 on the south side of the house roof. On the north side…

Hello, attached you can see our island's systems. In the portal, it would be good if we could show, for example, system P04, which is configured as an ESS, with a plus when there is a surplus. This takes the load off the 4 microgrids. Ebe…

Hello everyone, I’d like to tell you a little more about our off-grid system / microgrid. We currently use our four microgrids to supply our administration building, 6 EV wall chargers, a block of flats with 5 households, as well as …

I have install the virtual EV and EVCS in node red and have them both showing in node red with correct values however unlike battery charging with is separated from the AC load the EV charging is been recorded as both EV…

Hi I am having trouble getting AC 2 out to cut off at a set soc The sytem has a 600 amp NG batteries, Lynx ng smart bms, cerbo gx and 15kva Multiplus, I have set the assistants up and they are fine, the issue is that …

I noticed what appears to be a typo on the Multiplus 12/2000/80 manual. See attached pic where it references appendix A stating: “AC-In from right to left: N (neutral) PE (earth) L (phase)” which makes sense. But when y…

Hello, I have a Bayliner 4788 which has two 30 amp short power cords that I split one of them to go to three banks of circuit breakers. I’ve installed two Victron 4500w isolation transformers and I’ve done the wiring, bu…

I have been looking to enabling DVCC on my motorhome system. My setup is below, all on latest software. Battery is Fogstar Drift 608ah with internal BMS, Heater and temp sensor. Not networked. I also have a wired temp…

Incorrect consumption values are displayed on the individual phases on my Cerbo GX when used with the EM540 as a grid meter. My system consists of 3x Multiplus II 8000s, a Cerbo GX and an EM540 as a grid meter…

Low-battery alarms despite a battery voltage of 26 volts (Phoenix 24 V, 3000 W inverter).

I’m exploring a 48VDC/5000/120VAC Quattro build for a home, critical load battery backup system. Still in the design phase. I’m running into building code issues in Montgomery County Maryland with my original design, wh…

I have a 300 ahr victron lithium ng battery connected to a victron bus bms ng an a Orion dc to dc and a victron smart solar 30/100 mppt. I used the dc to dc and the mppt to charge the last 5% of charge, the mppt went in…