Forum Downeast Boat Forum

Taking a hard look at Building a 32 Millennium Walk Around. Advertised Cost of Boat is $200,000 for High End Commercial Finish. What i am trying to nail down is the cost for "everything" else. Including all electrical, panels, breakers, wire, cleats, rod holders, batteries, pumps, electronics, interior lighting , exterior lighting, helm chair, electronics etc. Does anyone have a list they are willing to share? Twin Suzuki 350HP's or equivalent. Lover my 31 BHM for 23 years, but thinking... Shopping List For New Build

I’m currently having my welder build me a gin pole. We have the material in the shop and I’m curious to see a bunch of different styles set ups. I’ll be installing in my washboard. The gin pole will be removable and there will be a sleeve that’s not removable from washboard to the cockpit floor. I’m not going to be able to through bolt to the floor due to access. I also need to be mindful of the screw length as my fuel tank is under the floor there. I was thinking screws that are shy of full... Custom gin pole

I'm looking at a repower of a Wasque 26' and considering Yanmar and Cummins. If I went the Cummins route with a 6bt 210 HP, what could I expect for wot and cruising speed? This presumes correct reduction and propeller selection along with a boat weight of about 5,800 lbs. fully fueled and loaded. I'll be doing a bare hull, stick built, rebuild and keeping things on the light side.

I'm not familiar with Nanni engines. I'm considering a 31' Bert with this power. Thoughts? Engine Make NANNI Engine Model 6.420 TDI Engine Year 2008 Total Power 320hp Engine Hours 730 Engine Type Inboard Drive Type Direct Drive Fuel Type Diesel

It's taken a couple years on and off but now I need this boat ready for 2021. I have the bracket, hauler, composite cores at the ready Picked it up for a song after it sank due to soggy foam, overweight motor, the usual. Going to be a hardcore fishing/diving boat. I'm widening the stern so it has a consistent beam while also making a chine/spray rail all at once. And just couldn't stand the look of a "pinched stern"

The Boat Basin at Block Island is hosting a get together Sept 11-13th. Contact Olin the Dock Master for details:

The Boat Basin at Block Island is hosting a get together Sept 11-13th. Contact Olin the Dock Master for details:

Quick question. Can I have two AGM batteries as house and a flooded for start. I only have a 1, 2, or all switch. And would it be bad to switch from agm to flooded through the all position real quick, not run them together, just switch over?

Buck Alogonquin 3BPBW200 packing wrench, 1-3/4 to 2", 3-1/4" jaw size. NIB never used. Will ship at buyer's expense.

So I have this lower cabin section not sure what to do with it. One is yes, I am going to making a cabinet for the electrical. As well as redo the 12VDC side as there is so much extra wiring right now. I am torn, as there is a large shelf behind the cabinet and just taking up space. Its an odd space, because if I made a cabinet against the wall, its to short to stand, unless your centerline in the cabin you would hit your head. I dont really want another settee down there, as I already have... Nauset/Bruno 35 - What to do with space

So I have this lower cabin section not sure what to do with it. One is yes, I am going to making a cabinet for the electrical. As well as redo the 12VDC side as there is so much extra wiring right now. I am torn, as there is a large shelf behind the cabinet and just taking up space. Its an odd space, because if I made a cabinet against the wall, its to short to stand, unless your centerline in the cabin you would hit your head. I dont really want another settee down there, as I already have... Nauset/Bruno 35 - What to do with space

Hello Forum, Bill D here with the 27 H&H. I boat on a strong tidal river (Piscataqua River, Portsmouth Kittery) The dock I now have is perpindicular to the tidal water flow. The bow thruster on the boat certainly helps with docking but with a 3ft keel the stern wants to go with the water flow. So, in my twilight years of boating I'm considering the install of an external stern thruster. The issue is the minimum amount of height above the waterline and the minimum amount of space above the... External Stern Thruster