Forum Nissan Navara

Could you provide instruction on how to set the engine timing on the Navara D23 please?

So 4x4 low doesnt seem to wanna engage on my 2021 Navara 4x4 manual. Beeps into 4x4 high and when going into 4x4 low it just flashes.. no other lights or noises

Hello i have joined this group to hopefully get some help with wiring in my new stereo. I am looking for a full wiring diagram for the internal radio wiring harness on a nissam mavara d40 (spanish built) cables alot of them are purple im assuming 1 purple to 1 other colour for each speaker. Cant find anywhere online a wiring diagram colour coded can anyone help. Previous owner has dry wired a strereo in and its all been done wrong. Balance and fade are out all the speakers are wired in... Nissan Navara D40 internal radio wiring harness

Hi all, I'm after the part number for exhaust gas temperature sensor 1 located on the manifold, accessible through a gap on the heat shield, and connects to the beige connector by the intake pipe. Ordered one from Nissan (22630-6MV0A) which is wrong and came as a harness with four sensors rather than the single sensor I need. I've seen another thread asking something similar, but the part number mentioned doesn't seem to tally up with the right sensor. Pic attached of the sensor location... Part number for EGTS 1 - 2016 NP300

Hi - my 66 plate Auto (with adblue) seems to have developed an EGR issue - sounds like the exhaust is blowing slightly but there are no issues with power or warning lights. Couple of questions - I am due to go on annual holiday on Saturday with a roughly 1000 mile round trip. It is booked into my local garage tomorrow but, if they can't fix it, is it OK to keep driving it? Secondly can anyone recommend somewhere in West Yorkshire that can will do a remap and blanking service to map out... Another NP300 with an EGR issue

I bought a Navara NP300 a few months ago and had a few issues, have fixed all of them apart from the rear Nox sensor. The original issue was the back Nox sensor had been corroded from water ingress and the plug was damaged with corrosion, so I soldered a new plug on and replaced the sensor with Febi 197505. On a test drive, the live data seems fine, both pre and post nox sensors are reading and adblue is showing as injecting. The post nox ppm is also drastically lower than the pre, so the... Nox Sensor issues

I have bouncing jittering feeling in a 2016 Nissan Navarra NP 300 automatic 4x4 I’ve replaced in the front end upper and lower control arms which include bushings ball joints replace front shocks rear shocks kept in the original springs my be not a good idea, New tyres balancing wheel alignment running Bridgestone Highway tyres. need help has anyone had the same problem? The only thing I haven’t changed really is the springs which are factory. everything I’ve had done was done at Pedders... NP 300 jittery bouncing feeling in front end at low speeds

has anyone had their fuel pump rebuit in England who could recommend somewhere, im in the process of removing the unit which isnt the easiest job in the world, thanks

I have a 2018 Navara NP300 twin turbo which has just covered 3000 miles. The Nav has been fantastic and has been a joy to drive from day one and has been on both long and short runs with a mix of motorway, country roads and town traffic. However, and this is the point of the thread, the ride seems to suddenly become very jittery/bouncy. I can feel every bump thru the driver's seat and it has become very annoying. If I was to describe it it is almost like the suspension has become softer... Bouncy/Jittery Ride Quality

Just recently I've noticed my NP300 (auto) whines. I can rev the engine in neutral and it sounds fine, but when I drive it there's a sort of continuous whine that I don't remember hearing previously. A sort of transmission noise. It's not loud, and reminds me of being on a bus listening to the gears changing up. It's just a bit irritating and I'm wondering if a bearing or something is on its way out.

Can anyone recommend a product or solution to get my canopy trim looking better? I scrubbed the plastic then used Meguiars plastic restorer. After about a month it started fading again. I then tried out the Gtechniq C4 plastic restorer. It now looks worse. Can this be painted or wrapped? Also the N-Guard Decals are all faded also, can these be brough back to looking good? TIA

Good morning from UK, my 2021 2.3 twin turbo has no power going up hills ,has no boost , turbos fine, new hot pipe seals , no errors or smoke only 2 things not checked air intake hose and boost sensor for actuator, so hose first as it's easier, where in the UK can I get a upgraded one as factory ones fail as they loose strength.thanks Alan