Forum RedSquare

Looking for a bagger attachment (the whole gizmo) for my 520H w/48" deck. My tractor I purchased in 1994 with 48" deck model 78360. I'm in Michigan. Any help appreciated!

Would anyone have one of the old style voltage regulators that have the screws to adjust the voltage?

48" (122 cm) Snow-Dozer Blade Package - Almost New, seldom used. 1 pair tire chains - lightly used 1 pair cast-iron wheel weights - seldom used All hardware included Stored indoors: minimal wear, no rust MUST PICKUP - NO SHIPPING/DELIVERY

48" (122 cm) Snow-Dozer Blade Package - Almost New, seldom used. 1 pair tire chains - lightly used 1 pair cast-iron wheel weights - seldom used All hardware included Stored indoors: minimal wear, no rust MUST PICKUP - NO SHIPPING/DELIVERY

Drive belt guard for models like: 1055, 1056, 1075 etc. One that fits a big block engine on a short frame tractor like the guard in the picture below. Thank you guys

Get this out of my sight. Tried to put on C195 and not happening. Free.

September 28,1850, United States Congress votes to ban flogging on both naval and merchant vessels. Until then, misbehaving sailors were often punished by stripping them to the waist and lashing their bare backs with whips known as cat o’ nine tails.

Cuts well and spindles spin quietly. Greased and maintained indoors for the four years I've had it. It has developed a hole in the deck near the height adjustment lever, as shown in the pictures. The U-Bolt around the lever is to provide additional support. Still works as it should and cuts nicely. You could weld a patch over the hole if desired. Mule drive came off another tractor but it appears to be in good condition. Cash on pickup on west side of Cincinnati.

Magnum 8 wheel horse spec engine. runs very well, no knocks, no smoke low hours. Video of it running are available at your request. PM me if interested. located in Mechanicsville, VA. Shipping available via fastenal at buyers expense. 425.00

Looking for a muffler for a C-81

Looking for a two piece gas tank. I plan to rebuild the tank so leaky is ok. However would prefer one that has good hood mounting holes, not all stripped out please. I also prefer if you could ship if not close. Thanks and I appreciate any help.

Like the title says what is it? It is marked Charger 10 on the side. But the motor looks original and is a 1976? Hydro drive manual lift. Starts right up too. Thanks