V1E.com Forum forum

(topic deleted by author)

power on machine , all motors energize if X is within 100mm of home it homes okay . than say i send it to X1200 no issues , than send it to X10 it travels sweet back to about X 300 than starts to shudder like its catch…

I was cutting a small item on my Primo and broke the bit, but don’t know why. I am cutting a 0.625" piece of red oak with a 1/8" compression bit (Spetool W02004, 3/4" cutting depth). This is cut in 5 passes, 0.1252" each…

Hello, This is my setup and I have been running my v4 low rider full sheet machine for months very well cutting out my coffee carts made from 18mm plywood My standard setup would be… doc = 4.6mm cutting a total depth…

It appears that primo doesn’t have a z end stop and relies on the probe to set the z height. I’m building a primo at the moment and have ordered a jackpot 3. I’m used to the concept of a machine having machine coordinate…

Hello! Over the last few weeks i have been building my LowRider V4, and it has been very funny, frustrating and amazing!:smile: We are now at the cutting phase, and have been cutting a bit. Right now we have a problem …

Hello! Over the last few weeks i have been building my LowRider V4, and it has been very funny, frustrating and amazing!:smile: We are now at the cutting phase, and have been cutting a bit. Right now we have a problem …

I’m brand new to this. I’ve been slowing putting together a Primo MPCNC, and this is my first major issue. I’m using Fluid NC on the Jackpot 3, a recent install of the yaml file from the Github. I’m at the point where…

I’m brand new to this. I’ve been slowing putting together a Primo MPCNC, and this is my first major issue. I’m using Fluid NC on the Jackpot 3, a recent install of the yaml file from the Github. I’m at the point where…

Has anyone had this issue before? Im cutting drawer slides out of 3/4” mdf. I just got the feeds and speeds dialed in at 3mm DOC @ 30mm/s. I also used a .5mm finishing pass. In the first image you can see a shadow…

Has anyone had this issue before? Im cutting drawer slides out of 3/4” mdf. I just got the feeds and speeds dialed in at 3mm DOC @ 30mm/s. I also used a .5mm finishing pass. In the first image you can see a shadow…

Im still unsure if what I have is the same issue as Michael on his last post. After some time cutting with no issue I started having problems today again. And the issue is that I started noticing that the machine seeme…