Harley Davidson Forums forum

I just bought a 1997 Fat Boy 39k miles turns out it needs a little more tlc than I was led to believe. Anyway, doing oil changes, replacing hoses, stripped out screws, adding washers, etc I've been chasing an oil wetness under the bike. At first I just put it off to needing an inner primary seal now I'm not so sure as I seem to have more wetness on the right side than the left. Today I got serious about finding it, so I get out my expandable mirror (Like a drug cop) and using a flashlight I... Chasing oil wetness

Hi all, I have a 2006 softail standard 12k miles. Im trying to adjust the rear suspension. started with factory turning clockwise then counter clockwise out four turns. they dont seem to be even, perhaps something else moved? note the clear banding on one is more than the other. Seems there are some bushings? See pics

I am putting on a BRUTE IV EXTREME POLISHED 3" OPEN BELT DRIVE ELECTRIC START WITH STD. OFFSET. Had the same setup but with a 1-3/4” belt and vented outer primary cover my question is when I took the old inner and outer primary clutch baskets off I did not loosen the clutch handle so when I put my new set up, should I loosen the front clutch cable? Thank you.

Ok folks. I’ve a 2020 Iron 883 and a 40 year old bad lower back. Hasn’t bothered me in years but lately it’s returned. I’m looking for a very comfortable solo seat; one that will support my behind and lower back. I’ve read about Mustang seats, but I can’t tell anything just by browsing. Any recommendations? And no, I don’t want to change bikes unless there’s no alternative. Thanks!

I am looking at a 2005 Roadster, seems in good condition. I've read something about a weak clutch? Are there any more trouble spots on this model? Thank You for any advice Mike

I got a 2009 fat boy no fairing or bags, planning on keeping it that way. But on my last ride down the open country I realized I would like some tunes after I quickly got bored of headphones. I ordered a set of boss speakers w/ amp, now I just realized I made a huge mistake. There’s really no good mounting places for an amp, since I don’t know much about bikes, and been trough a couple shortages already. What are y’all’s best option on mounting an amp, are getting bags the best solution? Any... Help looking for pointers on installing an amp on a Fat boy.

So I have a 2001 Heritage Softail Classic. Want to replace the amber turn signals with red LED bulbs. I know they are 1156 bulbs. I’ve tried two different brands , neither one turns and locks into the bulb socket. And yes, I tried turning it two different ways. Wont lock in place. Any suggestions?? TIA

I have the 2023 Heritage Classic Softail 114, FLHCS. There is an upper clutch cable and a lower clutch cable. I would like to know if the bottom clutch cable comes with the bottom part of the OEM Adjuster housing. I had cut mine off thinking that was what the instructions were telling or not telling me what to do. I have ordered a new bottom cable and intend to make sure it is working correctly at the transmission. But, the picture when ordering the cable shows the yellow piece in... Installing Fat Baggers EZ Clutch Adjuster

Does anybody have any thoughts on this set up also using all balls racing 1.4 starter NAO balls racing jack shaft and any thoughts would be appreciated. Also running a Mckinney carb and Andrew’s can.

Hi everyone, Can someone kindly point me in the right direction to the DLC port for the 2026 Softail models, specifically for the FXD? I'll be darned if I can find it. This is my first Softail - I'm coming over from the Touring side of things. Thank you a lot, T

New to the Harley scene, over the summer I inherited a 1200 Sportster Custom that my mother bought off the showroom floor in 2005. Been riding a couple years, but this my first name brand bike. It didn’t run when I picked it, but I got it going well enough to get a couple hundred miles on it so far.