Just thinking aloud, but could you use an electric fence kit to electrify a metal door so an intruder got a whack from it? I would like to use 240 volts, but repercussion would be tedious. I dont know enough about electrickery to know if it would work. I thought about it after seeing a clip where someone used a hand held fly zapper gubbins to put a charge to door handles on a van. I would prefer to electrify the whole metal door as there is no handle. Thanks.
Ktmforum forum
www.ktmforum.co.uk/threads/clutch-drag-when-warm.68515 ↗XenForo-forum in het Engels. 5 rubrieken gevolgd: Adventure, KTM General Discussions, Off-Road / Enduro, RC8 Superbike en Supermoto.
- Discussies per dag
- 5
- Opgehaalde discussies
- 202
- Berichten per dag
- 15
- Rubrieken
- 5
- Gevolgde bronnen
- 6
- Software
- XenForo
Laatste discussies
Elke 4 uur opgehaald uit de openbare feed van het forum. Alleen de titel, de link en het begin van het bericht worden weergegeven; elke link wijst terug naar de bron.
Are there any out there that are worth looking at? I have a mains unit but it's a faff to set up and clear away if I just want to give the bikes a quick once over. I have a detached garage that needs a long hose to get from the house water supply so a water tank fed by the garage roof seems like a simpler solution. Plenty of free solar off the garage to recharge the battery too. Any recommendations or are they still gutless toys?
What percentage as up to 100% . Do you ride standing on your KTM 690 R Enduro off highway ? Only 690’s please .
Hi. My 690 enduro 2023 tends to overheat when riding offroad in hot weather. How can I lower the temperature when fan starts? Searches tell me this is a mapping task not a sensor update? Any help appreciated. Cheers
Ik have a question when i ride my ktm 1290r evo after 30 min or so it start to act strange like.its getting to much or to low fuel. Then the mtc error pops up en engine light goes on then it looks like.its acting normal again same thing keeps happening if i delete the fault codes. Changed spark plugs changed map sensors cleaned coil pack it got 16500km on odo realy dont know what going on. Sometimes it read misfire And get the code p1151 and c2aoc
Afternoon all, Its time to lay this out, as I'm loosing my mind, and to be honest, I've lost all faith and need your help / thoughts to have any chance of moving forward. My original post is here, just to link it all up, but ill explain the story here, pictures will be attached too... Original Thread 2023 EXC-450 Six Days Purchased this new from KTM Fowlers of... '50 Hours and Me' - A Story about a 50Hr 23' EXC-450 bricking its top end - Your thoughts!?!
Hey everyone! I have been searching for the factory graphics kit (90608999000) for my orange duke 200 2014 but It's discontinued from KTM. Most aftermarket ones I've seen are a bit too much for my liking. Anyone have any opinions on the matter or some cool photos to share of their KTMs with sticker kits installed?
I rode home about 150 miles from a rally on Sunday on my 06 950SM. Mainly fast A and B-roads. All was great fun until I slowed, slashing and filtering through traffic. About 3 miles from home I glanced down at the clocks and the red oil light was on. Bugger! The bike was still running normally without any new engine noise or other indication. So I pulled over into a lay-by to try and figure out what was wrong. After a couple of minutes on the side stand I noticed a drop of oil on the... Bugger! Oil light on
Out on the 890smt today. It seems to run over when shutting the throttle. Can this happen due to a decat, lack of back pressure. Any feedback appreciated
Out on the 890smt today. It seems to run over when shutting the throttle. Can this happen due to a decat, lack of back pressure. Any feedback appreciated
Takes me back.....didn't know these were still being made. Pricey.... Facebook www.facebook.com
Takes me back.....didn't know these were still being made. Pricey.... Facebook www.facebook.com
202 discussies opgehaald sinds 8 September 2026. Volg dit forum op zoekwoord →