Ram Promaster Forum forum

I'm sure you've all seen the DIY water tubes some people have built on the roofs of their vehicles. Now that I'm traveling more in the van, I'm ready to install a built-in shower. Could that same concept work for the undercarriage? I've looked at tanks specifically designed for vans, but I'm not really happy with the way most of them sit underneath. My thinking is to lower the e-brake rod by about two inches, which would give me enough room for two 6-inch UPVC pipes mounted side by side... Idea for undercarriage water tank. Thoughts?

Getting ready to do a flush with a pressure bleeder. But was curious if anyone has found a way to do the abs pump also? I really don't see that option in AlfaObd unless I missed it?

I've used Blizzak snow tires on my car and they performed great in the winter. I was told the load rating for a PM2500 is 121. Blizzaks are only load rated to 115. Nokian Hakkapeliitta is load rated to 121. I'm not sure how much that matters or which tire performs better in the snow on a PM. The Nokians are a more expensive tire. Anyone have experience with either or both of these tires?

I know this has been talked about previously in this forum, but my passenger side rear door won't open. The handle doesn't seem to unlatch anything anymore. I tried opening it from the inside with no luck either. After further investigation the top latch near the roof seems to not come undone. Anyone know how I could fix this or at the very least manually unlatch it from the inside?

I'm beginning to think about it, so I'm planning it out! I might be trapped home taking care of a family member for a while, and if that's the case, I'll sell my van and start building the next one. Honestly I hope that's not the case, but I'm preparing myself for the worst scenario -- a year without travel. 😢 So I'm going through it on youtube, because Im an eyelash away from being monetized! And I love making videos. And I like helping people who care about design. I'm thinking a... my next build...

Am wondering what the purpose of the marker lights on top of the roof are for? Just appearances sake? The holes might come in handy for running wiring for a light bar. (Since my van isn't here yet, I'm enjoying fantasizing about many things I could add to it!)

Im not sure if this is the correct place for this question, but have any of you encountered a humming or buzzing sound on loop under the middle of the van? It happens on repeat every 20 ish seconds and lasts for 1-2 seconds. It doesn’t affect the driving or AC, but it is super consistent to the point where I can almost guess when the noise will happen. I attached a picture of roughly where the sound is coming from. For additional context on what the sound is like, it sounds like a motor... Vibrating/buzzing under van

Hi everyone, I wanted to share a little DIY project I’ve been working on that might be helpful to some of you. I originally designed and built rear door brackets for my Ford Transit because I didn’t want to drop close to $2,000 on a fully assembled door carrier. I’ve been selling those brackets on Etsy since January, and they’ve worked out great for folks wanting to build their own carriers. Recently, a couple of... DIY Rear Door Brackets for Custom Carrier Builds – Available Now!

Hi guys, I'm trying to get trans temp working on an Ultragauge MX. All documentation points to Scan Gauge codes being supported as custom "M gauge's" in the MX. Most documentation I've found points to the PID for tranny temp on the 2017 Promaster 3600 being 10F1229110. I'm following the "CAN Code Debugging" section of their manual, which is found here: https://ultra-gauge.com/ultragauge/support/UG-MX1.4-Supplement.pdf . I've also reached out to their support with the same... Ultragauge MX with tranmission temp (anybody gone down the rabbit hole?)

What is most effective way to sell 2018 promaster 2500 hiroof 159 wb that has been converted to 80% camper?

Hello all, My Promaster sliding door will not lock at all. After investigating, I found a cord in the lower right corner of the slider was severed. I’ve attached a picture but realized I probably should have zoomed out as well. I’m assuming this cord is the issue. Has anyone had this problem and is repaired it themselves? I can’t even figure out how to find out what part this is. It is not the actuator but it looks like the severed cable may have come from there. is it possible to... Sliding door issues

A friend's Promaster RV broke down in Kicking Horse Pass, BC. While descending the mountain pass, he heard a metallic sound followed by a big cloud of white smoke. The engine would turn over but wouldn’t start. The KIP app showed error code P0204. Any suggestions welcome. Hope I didn't violate any of this Forum's etiquette by asking this question.