SIG Talk forum

On this M11-A1, there is what I'll refer to as a "false break" when pulling the trigger in SA, at which point the trigger controls the hammer as though it were in DA mode. If you continue pulling the trigger, it will drop the hammer to fire a round. The GIF above, assuming it loads correctly, shows thumb cocking to SA, then trigger pull to false break, then using the trigger to gently lower the hammer as though releasing an incomplete DA trigger pull... P229 M11‐A1 SA Trigger Failure

Hi folks been awhile- I'm thinking about doing a TEXAS TRIGGERS Reaper FRT in my FLUX. I understand both sides of the discussion on FRTs in general but I have an extra FCU and want to have some fun. Has anyone done it yet?Problems or Failures?? Let me hear about it. Thanks Bob.. FLUX NATION!!

Recently acquired from a top-flight member here, who preyed mercilessly on my impulsiveness. 🤣 Two amazing specimens. The build quality and fitment of these P210 "A" models is beyond anything I've seen out of the Custom Shop, the Legion line, or the Reserve Collection. They feel hand-fit, and the action on the full size is also incredibly smooth and light. I've read others' descriptions comparing them to high-end custom 1911's, and I've got to say, I... Finally Joined the P210 Club

Hello, My friends and I are thinking about sending batch of Sig slides to get it refinished to Nitron. There are two slides that needs to be reblued, and other 8 is Sig Legion (green ish), that group want to refinish it Nitron black. Sig is requesting serial # of every single slide, and not sure why they need them for the slide refinish.. Question is, is it really have to be provided, and is this going to cause issue with any warranty in the future? Thank you

hello all. Ok, I have looked on here for my question and my research skills must be lacking because I couldn't find anythi g for my question. I am looking for 2 leather holester. One for my strong side(LEFT HANDED), and another for cross draw. Pancake owb. Will a holster that fits the m11a1 the same as one for the P228 or P229, or the P226. So I would be able to buy one and if it fits the p228, p229, or p226,,,will it fit my M11A1?? I am confused here so any help is greatly... Holsters for M11A1 left handed

From "YVK" over on the 1911 Forum: https://trademarks.justia.com/owners/sig-sauer-inc-2472976/page4 Second entry, a trademark for P385 filed 3 months back. Rumors around the web speculate a P365 design / P320 sized gun as a de facto replacement of a P320. Boom!

I wasn't sure exactly where this question belongs, but this probably makes the most sense. I've found surprisingly little discussion over SIG's P385 trademark. Does anyone have 1: any inside info or 2: some grounded opinions on what this thing could be? Is it just a "knee-jerk" reaction to how the Internet and basically everyone did the P320 dirty so they want to move past the name since it's basically been trashed forever? I'm hoping this is more than a quick, half-assed response to BS... Any P385 Conjecture Out There?

In an effort to provide this information, not available elsewhere with more recent manufacture dates, I'd like to start compiling a list of serial numbers and manufacture dates by model on SIG handguns manufactured in 2005 or later. If you would like to contribute, please post the serial number, production date, and model of your SIG handgun from the sticker. To protect your privacy, please substitute an "XXX" for the last three digits and I will add it to the list. Please limit the info... SIG post 2005 serial numbers - How to date your newer Sig handgun

I would appreciate suggestions as to why I am shooting my DA/SA P229 so poorly. (If it makes any difference, I was firing good quality 9 mm 115 gr fmj at 7 yards with a two handed grip. I am right handed. The sights were checked at the range and are well set. All shots were in SA. If it suggests what may be an issue, I blow the same 7 yard targets up with my 9 mm P365.) I made a change in my sight picture between the two targets. For the left target, I... Need Shooting Diagnosis

One day I’ll learn not to go to a gun show with cash in my pocket. Today was NOT that day. ;~} P229 Equinox .40 S&W

I'll just put this here....

Stopped in to pick up a transfer. Shouldn’t have even looked, but did not hesitate once I saw it and checked the case. It’s a 2005/6 North Carolina State Highway Patrol p229 DAK in .357 sig. It’s been fired, but not much. There is not a single blemish on the exterior of this pistol. E29-357-NCSHP