Simpletractors forum

Thanks to Ryan, and Andy I got the original 4B-116 back recently (that I built 20 years ago). I decided I should have a 1/16th scale of it in my toy collection. It was a fun project to do, and will keep my 100 series, and later the B-10's company.

Did anybody here get the bargain? I think it is a B12 with hydraulic lift and loader. I contacted seller an hour after it was posted but never got a reply. 45 minutes later it was marked sold. https://www.facebook.com/marketplace/item/4729938717236150/?ref=marketplace_profile&referral_code=undefined

Has anyone found a good paper air filter for a 1966 B-10 with Briggs 243431 engine?

On my landlord 2110, I put it in the breaker points cover. I wonder being closed up like that, the heat inside especially in the summer time is to hot. I have the nova 11.

The shorter spring-is this used on the landlord decks? It mite be part # 2154369sm.

Never seen a pulley break like this. It was installed in April, brand new. Everything still runs fine. What could cause it to break like that?

Anybody put a johnny bucket on a later model Sov?

I'm running an 82" belt in my 42" deck in my B110. Is that correct or are some of you guys running something different?

Not sure what will happen with the building and contents yet. This was my go-to for small engine machine work. Also ran an independent auto parts business out of the front.

I've been having trouble lately with the 48" deck on my mower. I keep getting an uneven cut, with strips that are higher, usually 30-32" apart. I've taken the mower off, cleaned out from under it, sharpened the blades as much as I could without removing them, checked that the blades are parallel and true to each other, as well as strait. I am cutting at nearly 3", but that hasn't been changed. Every time I mow, I check the from tire pressure, measure the axle height on both sides, fill rear tires to 10-15psi. Rollers are rolling. I thought at first then maybe the grass was so springy it wasn't coming back up from the front tire. The spacing isn't right. I've tried moving the in cut wheel over and it doesn't really eliminate the problem. It looks worse in person than in these paictures Anyone have any ideas?

Tractor will start up after 30 minutes or so. The fuel at the fuel filter is full, gas tank is full, have tried 2 new spark plugs and same results. Looking for ideas of what it could be. Has electronic ignition (nova).

Been a long time since I’ve changed it. Going to use Wix was something about anti drain back . Do I want that feature or not?