Fórum Victron Community

Hello everyone, I have a 3s3p 3.5 kwh implant. I use a victron of 150/45 A, and recently having strengthened the system the charge to the battery stops at 45 A, and of this I was aware of it. I load much better in the mo…

Hello everyone, System: Cerbo with Venus OS v3.79, dbus-fronius 1.7.20, Symo 15.0-3-M with firmware and Datamanager version, setting “int + SF”, model 160 starting at register 40253 Symptoms: Again and at regular interva…

More or less since the latest release of VRM, my DESS has strange behaviours. I am in green mode DESS, and it worked like a charme before. Now even if no grid consumption is planned or needed (enough in the battery), it …

I am charging a 24v lithium battery with solar and MPPT controller. When I monitor the charging using the AC charger it ramps up voltage very slowly 1/10th of a volt each time. How do I replicate this in the MPPT control…

QR1 PV power is insufficient, yet the PV array shows no fault

Hi there hope you can help with this problem we have had for last 6 months. Set-up: Roamer 230 leisure battery T6.1 Stop/Start Alternator with new battery Victron Lynx Power In 1000 fed by Orion-TR Smart 12/12…

Hi, looking for some advice please. We have a barge and are upgrading to lifepo4. The leisure side is 24v. The engine has 2 alternators one 70a 12v for the starter battery which is 12v and completely separate to the lei…

My System： a Victron SmartSolar MPPT, Victron GX Cerbo, and 24V lithium battery, with all communication cable connected. a problem arises when attempting to wake up a fully depleted (and shut-down) battery using the M…

Hello, I just purchased a 12.8V 100Ah SuperPack NG battery along with a Blue Smart IP22, SmartSolar 150/35 and Orion XS chargers. The chargers have built-in presets for Lithium batteries with the absorption voltage set …

What is the difference between victron BPC123048022 and BPC12304400? Anybody know?

Hello everyone. I am new to the forum so please excuse me if this question has already been answered. I am looking to purchase the above Multiplus II 12v/4000 watt 2x120v inverter charger for my RV and I need to get a …

I have an all Victron setup on my sailboat including multiple MPPT controllers, a Cerbo GX, Smart Shunt(s) and MultiPlus Inverter Charger. Since I can connect a battery temp sensor to either the Cerbo GX, MultiPlus or S…