Fórum OPNsense Forum

Gerade kurz nach dem Post zuvor funktioniert es: Description: ddnss.de Service: dyndns2 Username: eintragen Password: eintragen Wildcard: nein Hostname(S): eintragen Check ip method: dynu.ipv4 Interface to monitor: None Check ip timeout: 10

Hallo Zusammen, ich bin gerade dabei DDNSS.de in der aktuellsten Firmware einzurichten. Habe jetzt ein paar Sachen versucht, aber aktuell funktioniert es noch nicht. Habt ihr einen Tipp, wie man es am besten macht? Danke und Gruß Arthur

Quote from: muchacha_grande on August 26, 2026, 09:45:50 PM Unbelievable... doesn't make any sense. One thing previous core admitted to on developers@ last year is they didn't always bother with consensus or voting, and ignored / bypassed t...

I didnt check for issue one but I have issue 2. When I enable suricata, a few minutes later all network gone. And later a few minutes it start to work again but it gones again a minutes later. This repeats continuesly. I have crowdsec and suricata. Bu...

Danke nochmals! Wie viele habe ich auch die typische Admin Krankheit: "Handbücher...? Das ist doch nur was für Noobs". 🤭

Hi, das sind momentan zu wenig Informationen. Gehe bitte die Anleitung https://docs.opnsense.org/manual/how-tos/multiwan.html#multi-wan nochmals Punkt für Punkt durch und mache für jeden Punkt eigene Screenshots. Natürlich müssen beide Leitungen dabei ...

Quote from: Lucid1010 on Today at 01:54:26 AM Yes. I'd just like to disable the local port as well Port 323 is the control port, which is used to make changes by non-root users while chrony runs. E.g. with 'chronyc' from the command l...

Quote from: nero355 on September 16, 2026, 11:24:11 PM OK, but is it this for example I have no idea, I assume it's that but not sure. The driver is maintained by AMD AFAIK but OPNsense made changes too since their boxes use it.

Quote from: Patrick M. Hausen on September 16, 2026, 03:11:23 PM 127.0.0.1 is the loopback interface. It is not reachable from anywhere but the firewall itself. Yes. I'd just like to disable the local port as well.

Vielen Dank, aus dieser Anleitung und einer Hilfestellung aus dem Netz habe ich die OPNsense konfiguriert. Und: Die OPNsense funktioniert optisch auch entsprechend! Vorher war PLDT der Hauptzugang (weil Glasfaser), und wenn die PING-Zeiten bei PLDT ho...

Quote from: nero355 on September 16, 2026, 03:03:22 PM Post the output here and I will have a look for you too! If the output looks good I would do a filesystem check (fsck or ZFS scrub) and the Health Check that OPNsense provides to make sure there is...

**Title:** OPNsense HA + BGP with our own ASN and /24 — what architecture is recommended? Hi everyone, I would like to get some advice on the recommended architecture for using **BGP with OPNsense HA**, with two physical firewalls, our own IPv4 /24 pre...