Fórum RedSquare

I have a 603 I would like to trade for a 400-500 series tractor that’s hydro in southern pa

Hoping to pick up a mighty Mac chipper shredder attachment to use this fall. Local to CT but can travel around the area if you’re close. Thanks

1966 Wheel Horse Lawn Ranger L-156. Was used and running in the 80s, parked in a pole barn, and hasn’t been used since. Tecumseh engine. Call, text, or email 5186989503 emilyshafer88@gmail.com

Picking up a nice 754 next week and would like to add headlights to it. I'd like to find (or piece together) and HL-5 kit. Otherwise, I'll need to fab up something similar on my own. Picture for attention.

Have a GREAT day

We see a lot of questions regarding faltering engines under load. Heat sink problems. Testing procedures for ignitions. These two videos show some very good information about the subject. The first one, about the spark plug gaps, gets particularly intuitive around the halfway point.

Marketplace listed.. what model? Seller asking $200.00. Hasent Ran in years, needs carb rebuild, always been in same family ad states.

Warn Provantage 50" Dump Bucket #84133. Plow and dump bucket for ATV/UTV. Works with winch on ATV/UTV (NOT INCLUDED). Winch lifts bucket and rope pull releases bucket to dump contents. Used Lightly. My ATV is too small for this bucket. Comes with self-fabricated front mount for lawn tractor. You will need to purchase or fabricate mount for your specific vehicle. Fifty inches wide x approx 12" deep x approx 18" high. Please see pictures and contact me for any more information.

I recently installed the hitch assembly on a C161 auto. One of the issues I have is length of travel or lift motion. I am using a short clevis up front and chain in the rear on a slot hitch. Do I need to screw in the trunion on the cable? Currently the cable is at the end of the trunion and I can't really use less chain links.

B100 8 speed and short chute snowblower for sale near Indianapolis Indiana. good deck and tires, engine runs. transmission needs axle seals and bearing. too many projects, not enough room.

Just picked up this 79 C141 for cheap not running. Found out the lobe on cam for fuel pump was rounded so I put an electric pump on it. Runs good, shakes like crazy. What are you guys doing for replacement bushings on this shaker plate? This is my first one with this setup, all my others were mounted directly to frame. IMG_0958.mov

Hello, good afternoon from Spain. I’d like to install a pedal-operated throttle on my 702; has anyone done this modification who could share some ideas and perhaps a photo? Thanks.